-
One-drive-two Stepper Drive R60-D
Two-axis synchronization appication is often required on the conveying equipment. R60-D is the two-axis synchronization specific drive customized by Rtelligent.
Speed control mode: the ENA switching signal controls the start-stop, and the potentiometer controls speed.
• Signal level: IO signals are connected to 24V externally
• Power supply: 18-50VDC
• Typical applications: conveying equipment, inspection conveyor, PCB loader
• Using the TI delicated dual-core DSP chip, R60-D drives the two-axis motor independently to avoid the interference whthin
• the back electromotive force and achieve independent operation and synchronized movement.
-
One-drive-two Stepper Drive R42-D
R42-D is a customized drive for two-axis synchronization application
In conveying equipment, there are often two – axis synchronization application requirements.
Speed control mode: the ENA switching signal controls the start-stop, and the potentiometer controls speed.
• Signal level: IO signals are connected to 24V externally
• Power supply: 18-50VDC
• Typical applications: conveying equipment, inspection conveyor, PCB loader
-
Classic 2 Phase Open Loop Stepper Drive R60
Based on the new 32-bit DSP platform and adopting the micro-stepping technology and PID current control algorithm design, Rtelligent R series stepper drive surpasses the performance of common analog stepper drive comprehensively.
The R60 digital 2-phase stepper drive is based on 32-bit DSP platform,with built-in micro-stepping technology & auto tuning of parameters. The drive features low noise, low vibration, low heating and high-speed high torque output.
It is used to drive two-phase stepper motors base below 60mm
• Pulse mode: PUL&DIR
• Signal level: 3.3~24V compatible; series resistance not required for the application of PLC.
• Power voltage: 18-50V DC supply; 24 or 36V recommended.
• Typical applications: engraving machine, labeling machine, cutting machine, plotter, laser, automatic assembly equipment, etc.
-
Switching Stepper Driver Series R42IOS
Featuring built-in S-curve acceleration/deceleration pulse generation, this driver requires only simple ON/OFF switch signals to control motor start/stop. Compared to speed-regulation motors, the IO Series offers:
✓ Smoother acceleration/braking (reduced mechanical shock)
✓ More consistent speed control (eliminates step loss at low speed)
✓ Simplified electrical design for engineers
Key Features:
●Low-speed vibration suppression algorithm
● Sensorless stall detection (no additional hardware required)
● Phase-loss alarm function
● Isolated 5V/24V control signal interfaces
● Three pulse command modes:
Pulse + Direction
Dual-pulse (CW/CCW)
Quadrature (A/B phase) pulse
-
Intelligent 2 Axis Stepper Motor Drive R42X2
Multi-axis automation equipment is often required to reduce space and save the cost.R42X2 is the first two-axis special drive developed by Rtelligent in domesitic market.
R42X2 can independently drive two 2-phase stepper motors up to 42mm frame size. The two-axis micro-stepping and current must be set to the same.
• peed control mode: the ENA switching signal controls the start-stop, and the potentiometer controls speed.
• Signal level: IO signals are connected to 24V externally
• Power supply: 18-50VDC
• Typical applications: conveying equipment, inspection conveyor, PCB loader
