-
Pulse Control 2 Phase Closed Loop Stepper Drive T86
The Ethernet fieldbus-controlled stepper drive EPR60 runs the Modbus TCP protocol based on standard Ethernet interface
T86 closed loop stepper drive, based on 32-bit DSP platform, built-in vector control technology and servo demodulation function, combined with the feedback of closed-loop motor encoder, makes the closed loop stepper system has the characteristics of low noise,
low heat, no loss of step and higher application speed, which can improve the performance of intelligent equipment system in all aspects.
T86 matches closed- loop stepper motors below 86mm.• Pulse mode: PUL&DIR/CW&CCW
• Signal level: 3.3-24V compatible; serial resistance not required for the application of PLC.
• Power voltage: 18-110VDC or 18-80VAC, and 48VAC recommended.
• Typical applications: Auto-screwdriving machine, servo dispenser, wire-stripping machine, labeling machine, medical detector,
• electronic assembly equipment etc
-
Pulse Control 2 Phase Closed Loop Stepper Drive T60Plus
T60PLUS closed loop stepper drive, with encoder Z signal input and output functions. It integrates a miniUSB communication port for easy debugging of related parameters.
T60PLUS matches closed loop stepper motors with Z signal below 60mm
• Pulse mode: PUL&DIR/CW&CCW
• Signal level: 5V/24V
• l Power voltage: 18-48VDC, and 36 or 48V recommended.
• Typical applications: Auto-screwdriving machine, servo dispenser, wire-stripping machine, labeling machine, medical detector,
• electronic assembly equipment etc.